3in1 SRAM test v2

1-The .nds files are pre-patched for EZ5 use.
2-Place the 3 files onto the root of your media card (2 .nds and 1 .gba).
3-Run write.nds and if it doesn't mention any errors you are good to go.
4-Reboot and run verify.nds, it will then re-check the data against what was written in step 3
5-take the 3in1 out of the DS, wait some time, put it back and run verify.nds again.

If you don't get any verify errors, your SRAM is working fine.

**warning** the write app WILL overwrite your 3in1's SRAM, any save data you have on it will be lost.

Hope this helps test for faulty hardware.

Cory

v2 	updated by mbmax request to support two new 3in1 revisions (untested)
	updated to later libfat/dkpro base
